TC-01
Site & switchboard survey
Free desktop review plus on-site inspection across Brisbane to confirm capacity, cable run and RCD/OCP requirements.
Tesla Certified · Brisbane · QLD
Tesla Wall Connector installation in Brisbane.
Certified Tesla Wall Connector installs across Greater Brisbane. Gen 3 22 kW hardwired, load-managed and Powershare-ready — engineered by CEC-accredited ESQ electricians.
01 — Overview
ESQ installs the Tesla Wall Connector (Gen 3) at homes and businesses across Brisbane — from Ascot to Springfield, Redcliffe to Logan. Every install is scoped against your switchboard capacity, hardwired to Australian Wiring Rules, tested with your Tesla, and lodged with Energex. Fixed pricing after site survey, no sub-contractors.
Homes & apartmentsWorkplacesDealershipsBody corporatesHotels & short-stayFleet depots
Spec Sheet
- Charger
- Tesla Wall Connector Gen 3
- Output (3-phase)
- Up to 22 kW / 32 A
- Output (1-phase)
- Up to 7.4 kW / 32 A
- Cable
- 7.3 m tethered Type 2
- Load management
- Up to 16 chargers on one circuit
- Powershare
- Cybertruck / Model 3 & Y ready
- Approval
- Energex Form A · CEC accredited
- Warranty
- Tesla 4-yr hardware · ESQ 5-yr workmanship
02 — Capabilities
What ESQ delivers across this practice.
TC-02
Hardwired Gen 3 install
Direct-wired to the switchboard with a dedicated Type A+DC 6mA RCBO — no plug-in adapters, no compromises on charge rate.
TC-03
Load management
Configure up to 16 Wall Connectors on a shared supply for dealerships, workplaces and multi-car homes.
TC-04
Switchboard upgrades
Main-switch, meter-panel and consumer-mains upgrades where existing capacity is insufficient.
TC-05
Solar integration
Pair the Wall Connector with your PV and battery so you charge on excess solar during the day.
TC-06
Energex approvals
We lodge the Form A EWR and any embedded-generation variations required for higher-capacity installs.
03 — Delivery
A disciplined, engineered process.
- 01
Quote
Photos of your switchboard and meter — same-day fixed quote.
- 02
Survey
On-site scope, cable route, and Energex paperwork prepared.
- 03
Install
Half-day install, tested against your Tesla and commissioned in the app.
- 04
Support
5-year workmanship warranty and ongoing firmware/OTA support.
04 — FAQs
Common technical questions.
- How much does a Tesla Wall Connector installation cost in Brisbane?
- Standard single-phase installs from $1,290 inc GST supplied and installed. Three-phase, switchboard upgrades or long cable runs are quoted after site survey.
- Do I need three-phase power?
- Not required — single-phase delivers up to 7.4 kW, enough to add 300+ km overnight. Three-phase unlocks the full 22 kW for faster daytime top-ups from solar.
- Are you a Tesla Certified installer?
- Yes. ESQ is CEC-accredited and installs to Tesla's certified installer specification, with the required Type A+DC 6mA RCD protection.
- Can I charge non-Tesla EVs?
- Yes. The Gen 3 Wall Connector is Type 2 and charges any Type 2 EV sold in Australia — Polestar, BYD, Kia, Hyundai, MG, BMW and more.
Book your Brisbane Tesla install.
Brisbane HQ, servicing all of Australia. 48-hour response on commercial briefs.